Weed Eater WE EL-11 Bedienerhandbuch PDF herunterladen (Seite 12)

12

5. Wind the line evenly and tightly onto the

spool. Wind in the direction of the arrows

found on the spool.

6. Push the lines into the notches, leaving 3

to 5 inches (7 -- 12 cm) unwound.

7. Insert the lines into the the exit holes in

the hub as shown in the illustration.

8. Align the notches with the line exit holes.

9. Push spool into hub until it snaps into

place.

10. Pull the lines extending outside of the hub

to release the lines from the notches.

LINE REPLACEMENT

(Models W25CF, W25SF, W25CFK,

W25SFK)

WARNING:

For models W25CB,

W25SB, W25CBK, W25SBK, use only 0.080

inch (2 mm) diameter line. Other sizes of line will

not advance properly and will result in improper

cutting head function or can cause serious

injury. For models W25CF, W25SF, W25CFK,

W25SFK, use only 0.095 inch (2.4 mm) diame-

ter cut length line. Do not use other materials

such as wire, string, rope, etc. Wire can break

off during cutting and become a dangerous pro-

jectile that can cause serious injury.

For unit to operate properly, the cutting line

should be replaced when line becomes worn

to less than 3 inches in length from the edgeof

each side of the cutting head.

1. Remove and discard worn line before

installing new line.

2. Clean entire surface of cutting head.

3. Insert ends of line into the two guide holes

on front of cutting head.

Guide

Hole

Guide

Hole

4. Continue to feed line through the guide

holes until the line is fully extended

through the side exit holes.

Side Exit Hole

Side Exit

Hole

5. Pullends of line until line is tight. Correctly

installed line will be the same length on

both ends.

REPLACING THE TRIMMER HEAD

(Models W25CB, W25SB, W25CBK,

W25SBK)

1. Hold the dust cup with a wrench to keep

the shaft from turning while removing and

installing trimmer head.

Dust Cup

2. Remove trimmer head by turning counter-

clockwise (looking from bottom of unit).

3. Thread replacement trimmer head onto

the shaft by turning clockwise. Tighten

until secure.

REPLACING THE TRIMMER HEAD

(Models W25CF, W25SF, W25CFK,

W25SFK)

1. Align holein the dust cup with the hole in the

side of the gearbox by rotating the dust cup.

2. Insert a small screwdriver into aligned

holes. This will keep the shaft from turning

while removing and installing trimmer head.

Screwdriver

3. While holding the screwdriver in position,

remove trimmer head by turning clockwise

(looking from bottom of unit).

4. Thread replacement trimmer head onto the

shaft by turning counterclockwise. Tighten

until secure.

5. Remove the screwdriver.

IDLE SPEED ADJUSTMENT

WARNING:

Keep others away when

making idle speed adjustments. The trimmer

head will be spinning during this procedure.

Wear your protective equipment and observe

all safety precautions.

The carburetor has been carefully set at the

factory. Adjustment of the idle speed may be

necessary if you notice any of the following

conditions:

S Engine will not idle when the throttle is re-

leased.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare